Chef CHI643BA Manual de usuario descargar pdf (Pagina 10)

care and cleaning

10 CARE AND CLEANING Induction Cooktops

Clean the appliance after each use. Always use cookware

with clean bottom.

WARNING

warning

Sharp objects and abrasive cleaning agents can cause

damage to the appliance. For your safety, do not clean the

appliance with steam cleaners or high-pressure cleaners.

TIPS & INFORMATION

tips & information

Scratches or dark stains on the glass ceramic cause no effect

on how the appliance operates.

If you tried the above solutions and cannot repair the problem,

speak to your dealer or our Customer Care team. Give

the data from the rating plate, three digit letter code for the

ceramic glass (it is in the corner of the glass surface) and an

error message that comes on. Make sure, you operated the

To remove the dirt:

1. • Remove immediately: melted plastic, plastic foil, and

food with sugar. If not, the dirt can cause damage to

the appliance. Use a special scraper for the glass. Put

the scraper on the glass surface at an acute angle and

move the blade on the surface.

• Remove after the appliance is sufﬁciently cool:

limescale rings, water rings, fat stains, shiny metallic

discolourations. Use a special cleaning agent for glass

ceramic or stainless steel.

2. Clean the appliance with a moist cloth and some detergent.

3. At the end rub the appliance dry with a clean cloth.

appliance correctly. If not the servicing by a customer service

technician or dealer will not be free of charge, also during the

warranty period. The instructions about the customer service

and conditions of guarantee are in the guarantee booklet.

How to resolve problems with your cooktop

Problem

Possible cause and remedy

You can’t activate the cooktop or operate it.

• Activate the appliance again and set the heat setting in 10 seconds.

• You touched 2 or more sensor ﬁelds at the same time. Only touch one sensor ﬁeld.

• There is water or fat stains on the control panel. Clean the control panel.

The cooktop deactivates.

An object has been placed on the

button. Remove the object from the sensor ﬁeld.

The residual heat indicator does not come on.

The cooking zone is not hot because it operated only for a short time. If the cooking zone is hot, contact

our Customer Care team.

The sensor ﬁelds become hot.

The cookware is too large or you put it too near to the controls. Put large cookware on the rear cooking

zones if it is necessary.

comes on

The Automatic Switch Off is in operation. Deactivate the appliance and activate it again.

comes on

• No cookware on the cooking zone. Put cookware on the cooking zone.

• Not correct cookware. Use the correct cookware.

• The diameter of the bottom of the cookware is too small for the cooking zone. Move cookware to a

smaller cooking zone.

and number comes on

There is an error in the appliance. Disconnect the appliance from the electrical supply for some time.

Disconnect the fuse from the electrical system of the house. Connect again. If

comes on again,

contact our Customer Care team.

comes on

The Automatic Switch Off operatres when the cookware on the appliance boils dry. Deactivate the

appliance. Remove the hot cookware. After approximately 30 seconds, activate the cooking zone

again.

will disappear from the display but the residual heat indicator will be shown until the

cookware and appliance has sufﬁciently cooled down. Refer to the Cookware section for correct

cooking temperatures.

Red rings, limescale or water rings, shiny

metallic or other discolouration, scratches/

shadows, bubbles or other miscellaneous marks

or stains on ceramic glass cooktop surface.

Cooktop surface has not been cleaned correctly. Cleaning/maintenance of the cooktop surface

is not covered under warranty. If a service call is placed to clean the cooktop you will be

charged for the visit. Use a ceramic glass cleaner such as Cerapol.

Pitting of ceramic glass surface.

Spills of liquid with high sugar content. These types of spills must be removed immediately with a

special scraper for the glass. If not permanent damage to the cooktop glass can occur which is

not covered under warranty.

The heat setting changes between two levels. The power management is activated. Refer to ‘Power management’

comes on

The Child Safety Lock device or the Lock function operates. Refer to chapter ‘Operating instructions’.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Chef CHI643BA Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Chef CHI643BA