Chef CHE655SC Manual de usuario descargar pdf (Pagina 9)

Problem Possible cause Remedy

comes on

There is an error in the appli-

ance, because a cookware

boils dry. The protection

against become too hot for the

cooking zone operates. The

Automatic Switch Off operates.

Deactivate the appliance. Re-

move the hot cookware. After,

approximately 30 seconds acti-

vate the cooking zone again.

should go out of the dis-

play, residual heat indicator can

stay. Let the cookware become

sufficiently cool and check it

with the section Cookware for

the induction cooking zone.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION

Warning! Refer to the Safety chapters.

Before the installation

Before the installation of the appliance, re-

cord the information below from the rating

plate. The rating plate is on the bottom of

the appliance casing.

• Model ...........................

• PNC .............................

• Serial number ....................

Built-in appliances

• Only use the built-in appliances after you

assemble the appliance into correct built-

in units and work surfaces that align to

the standards.

Connection cable

• Use the correct mains cable of type

H05BB-F Tmax 90°C (or higher) for a sin-

gle phase or two phase connection.

• Replace the damaged mains cable with a

special cable (type H05BB-F Tmax 90°C

or higher). Speak to your local Service

Centre.

To attach the seal.

• Clean the worktop in the area of the cut

out section.

• Bond the seal stripe supplied on the low-

er edge of the appliance along the outer

edge of the glass ceramic. Do not extend

it. Let stay the cut ends in the middle of

one side. When, you cut it to length (add

some mm), push the two ends together.

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios